PRODUCT

DATA SHEET

GEL COAT

COATING

PART #: AT-M1-50

DESCRIPTION

AUTOTRIZ Gel Coat Coating is formulated specifically for epoxy and polyester gel coats. It is an unique Nano ceramic coating that seals your gel coat of your boat, yacht or jet by forming a high gloss protective layer with ultra smooth hydrophobic characteristic that blocks out harmful UV rays and repels acid rain, oil, fuel spills and other contaminants.

AUTOTRIZ Gel Coat Coating offers excellent chemical resistance that can withstand corrosion from salt water and it cannot be removed by cleaning chemicals.

PROPERTIES

- Permanent bond 

- >9H pencil hardness
- Excellent protection against rain and sun damage
- Easy-to-Clean
- Excellent adhesion to gel coated surfaces
- Outstanding weather resistance 
- High UV and salt water resistance

- Prevents fading and oxidation
- Superior to Siloxane based coating

APPLICATION

Gel Coat Coating is particularly suitable for gel coat of boats, yachts and jet skis. 

TOOLS

Gel Coat Coating can be applied with microfiber applicators.

TECHNICAL DATA

Appearance: Colourless

Density: ca. 0,86 g/cm3

Base: Organic + Inorganic Polysilazane

Curing: Normal ambient temperature/ 80° celcius

Shelf Life: 12 months

Container Size: 50ml

INSTRUCTIONS FOR USE

The product is for professional use and should be applied by approved applicators only. Test on a small area or apply a test coat before application.

APPLICATION OF GEL COAT COATING

Shake well before use.

Get ready with 3 pieces of brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)

When first applying Marine Gel Coat on substrate, it is recommended to condition the surface of the applicator block with 7-8 drops to prevent skipping or dry spots.

Do not work on large area at a time. It is recommended to do a 4 ft. x 4 ft. area at a time.

Apply Marine Gel Coat using normal pressure on applicator. Make sure the area is well covered. Always start from an edge to avoid excess on other panels. Work in controlled areas to remember where you previously applied. Work in horizontal or vertical movements repeatedly to ensure that product is penetrated through gel coat

Wait for 5-10 minutes. Use first towel to level the product.

Go immediately over with second microfiber towel with polishing motion until the surface is free from residue.

Follow by the third towel (this is called the “insurance towel”) and go over the surface one extra time just to make sure you haven’t miss any streaks or excess residue just to make sure you haven’t miss any streaks or excess residue.

When the whole boat is applied, allow curing of coating to begin.

Wait approximately 30-60 minutes before applying a second layer.

Allow curing of coating to begin.

© 2019 AUTOTRIZ WORLDWIDE. 

All rights reserved.

Customer Support

Phone No: +6011 5626 3898